Engine radiator Nissens or OEM Toyota
I just installed a nissens. went fine, good fit.
I just looked on rockauto. Buy the Nissens 61033. HD cooling radiator. They are an OEM manufacturer. And it’s only $154. Fraction of the cost of Mopar, and the same quality.
I replaced mine with a Nissens and it’s been working great for over a year. The way the drain plug felt when I installed it was a bit concerning though.
Another vehicle the rad got low and the stream pretty much melted the top where it connected to the hose. New rad was on backorder and I needed a car so I cut the melted but off at a clean angle and attached a chunk of ABS pipe using high-temp JB weld which I reattached the hose too after it set. I regularly checked it over the next 1-2 weeks until the shop got a new rad in and had no issues.
Pretty sure oem is mahle but nissens are good for sure
Nissens rads are very good tbh, better than OEM,
I've recently replaced my original oem one with Nissens, no issues so far, works perfectly. it was a super easy install and no issues so far.
I got a Nissens radiator in mine after it had to be replaced last year, and it’s been serving me very very well
Shortly after owning it I had to replace radiator, Dan shroud. Then my power steering rack and CV died. Just recently my master break cylinder just died
My NISSEN didn't last 2 years before it failed catastrophically on the plastic side tanks.
Write your review
Help others - share your experience with this part.
Engine radiator MISHIMOTO or Koyo
Engine radiator MISHIMOTO or Nissens
Engine radiator MISHIMOTO or KOYORAD
Engine radiator MISHIMOTO or Denso
Engine radiator MISHIMOTO or OEM Volkswagen
Engine radiator MISHIMOTO or OEM BMW
Engine radiator Koyo or Nissens
Engine radiator VALEO or MISHIMOTO
Show all