Oil filter Motorcraft or Hengst
Personally I’ll ONLY use the manufacturer filters on my vehicles and I’ll look through the catalogs to find the largest filter that fits. I’ve been using Motorcraft FL1As on my pu for the 28 years I’ve owned it and it’s cheap insurance.
I've always had good luck with the FL 820s in a 3.0.
For oil filter, I run the same one on my 302 and 390: Motorcraft FL-1A. I believe it is (or was, at least) made by Purolator and is my go-to for my old Ford V8s.
Tiguan owners, I can tell you from experience that you don't need to go under the car to install this! You have to reach for the boost sensor but everything can be done from up top!
I have several VAG cars and perform changes at 5k, Liquimoly kits from FCP Euro, always use a quality OE filter such as Hengst, save your records and any reasonable buyer will understand.
First of all, change the brand of the oil filter and do the same test again. My recommendation is Hengst filters, same quality with Mann and Bosch, made in the same factory in Slovakia.
I have had good results with the Hengst. Recently ran a Hengst to 20,000 miles. It’s was a bit crispy but was doing just fine.
I use Motorcaft synthetic oil and filter. It's what the manufacturer recommends. There are probably 50 other oils out there that are just fine for regular driving and the occasional burnout. I just tend to stick with what the people who designed the engine would recommend over what someone on the internet does, unless there is a clear reason not to. And if you disagree, you do you.
Official VW filters are Hengst's with a little VW logo and part number printed on the end just note that the filters do not include the gasket for the oil-can drain plug (dunno if that's on the mkIII's, but it's on the mkIV's). Just means you can't really drain the can, just unscrew it and be quick to minimize the amount of oil that goes flying
I've seen those leaking at the crimp now multiple times.
Write your review
Help others - share your experience with this part.