Denso for my runner
Make sure you use genuine NGK plugs, otherwise you will have problems.
Denso or NGK. Buy them from a real vendor not eBay or Amazon or anything like that
Replace with OEM - Denso. And yeah, get them from rock auto. Anywhere else is way too expensive and eBay is most likely counterfeit garbage.
I got a new set put in some NGK’s.
OEM are actually cheaper than a lot of aftermarket plugs. Buy from a place like bell Lexus or just get the denso branded equivalent. They last hundreds of thousands of miles in some cases, so OE has certainly proved its worth
Yeah, NGK's are great. Get the best you think you can afford.
i got a cheap 80cc kit a while ago and it ran awesome for about 3 months, then i let it sit for almost a year in a garage. Now rusted in some places, but still spins freely, and piston is intact. I just installed a centrifugal clutch and a pull starter, along with a new cdi and new coil, but it just wont start no matter what. I keep pulling and pulling and nothing. I even got a lower temp spark plug for it (NGK B7HS). Fuel is going in, carb seems to be working, i believe im using good enough fuel, tried many different fuel/air mixes... but nothing. Can anyone here please help me figure out what could be wrong? If you need any additional info please ask.
EDIT: after some back and forth with the comments, i decided ill try and disassemble/clean the carburetor, and maybe some other things suggested.
I also realize my formatting isnt the best, but this was one of the first few times i posted in reddit, ever...
And to address me just chucking in new parts suddenly? yeah, not the best move, i realize, but ill try and make it work, and a lesson learned.
Anyway, thank you for the help everyone! I very much appreciate it. Perhaps ill post an update on whether i managed to get it running or not
UPDATE: Today i tried most of what you all suggested and unfortunately, still nothing. I opened the carburetor, as clean as could be.
At this point, my only two suspecrs left is the crankshaft magnet getting misaligned, or im just not getting enough rpm with the pull starter, which is already kind of bogus because it produced a decent spark even when not pulling too fast
I changed the plugs on my 2017 raptor recently with NGK iridium plugs. The punchline is that the truck started backfiring when I pushed it. I ended up putting Motorcraft plugs in and it cleared up.
The previous owner had installed some Denso IKH24's that looked..... disgusting. In fact, I have NO CLUE how the car ran as well as it did, as the tips from the Denso plugs were gone, and the gap was 0.055. The car still had a slight miss after I did the coils last month which prompted me to replace the plugs.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads OEM Alfa Romeo got the first review!
The brake caliper OEM BMW got the first review!
The brake pads OEM Infiniti got the first review!
For wiper blades PIAA already 100 reviews.
For battery Energizer already 25 reviews.
In the rating best water pump already 12 brands participate!
In the rating best timing belt already 13 brands participate!
In the rating best head gasket already 3 brands participate!
In the auto rating oil filter for Volkswagen Passat already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating tires for Subaru Outback already 50 brands participate!
For cabin filter Fram already 25 reviews.
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
