Jetta headlights
Reviews of OEM Volkswagen parts For Business
Germany
I replaced the spark plugs, ignition coil plugs, alternator and checked the tensioner.
had so much fun today! no videos unfortunately but first in class and almost upset an STH guy, lol the car did great on the 240tw, 41psi. sport mode with esc fully off. lots of grip even though i was overdriving a bit.
Great if taken care of!
I have a 2016 Golf 5MT, 160k mi now. It's been tuned for 120k and only major issue I've had is the original water pump went out last spring at approx. 140k.
I did first oil change on Atlas at 5k then did 10k changes, but the 3.6 is lethargic compared to the GTI which I have been doing about every 4k miles.
After doing a complete OEM parts timing job my numbers were actually initially worse 7 and 8. After driving the car for 1 tank of gas the 209 number went slightly down to 4 and 208 stayed at 7, also 90 and 91 are still flip flopped.
Head gasket replacement was an issue with 2018 and early 2019 models. Not 2020s. When mine was replaced my bumper was scratched at the bottom of the lights, the grill and headlights were out of alignment and parts were missing from the area that redirects air through the radiator.
Secondly, defective Rear Disk Brake Pads that wore out on a majority of 22` Taos which was a covered rear Brake replacement if it was under 2ydears and 24 months. I just missed the cut-off and was$700 poorer.
As a mechanic who used to work on these cars daily, it really depends if you're willing to fork out the amount that's due every couple of years, the water pumps on vw/Audi/ Porsche and mercs are always prone to fail within a couple of years even if you go aftermarket.
My front brake rotors warped at ~12K miles. I had them machined and they lasted about another 12k until I replaced them with aftermarket Centric. Those lasted ~12K miles until they warped. At this time I went back to VW OEM rotors and they lasted ~12k miles. I had the OEM's machined, but now they are warped again. Along the way I tried some aftermarket pads, and generally had problems I purchased a pair at NAPA and they were sloppy in the caliper and would shift and click when applying the brakes in reverse. Went back to OEM on the pads and have no problems.
Write your review
Help others - share your experience with this part.