Brake pads EBC or POWER STOP
PowerStop ceramics. I put them on the fronts. Dust was crazy on the OEMs
Unless you do extreme driving (lots of mountains runs, hot laps on track, etc) slotted and or drilled rotors are a waste of money. They will cause much higher pad wear. Spend your money on good pads and buy meh rotors to get best bang for your buck and longevity.
Powerstop z23/z26 are both pretty good, have ran a couple sets.
I went with EBC slotted with EBC red pads and it made a total difference in the bite and consistency of the braking on my 7.5.
I run the dimpled and slotted versions along with EBC yellow pads and they grab WAY better than stock in every comparable way. The initial bite on the pads when cold and hot is significantly better and they resist heat much longer too.
Running EBC Yellow's at the moment.
I went with EBC Reds (ceramic, low dust) as they have a decent reputation. EBC brakes do not include the standard brake kit hardware.
The z23 pads handle heat better but they’re not that aggressive in terms of needing to warmup. Its still very much a street pad. For me pedal pressure feels stiffer but slightly spongier than stock if that makes sense. Not a bad thing just something to get used to, and you get used to it quickly. I’d recommend them.
My experience with PowerStop (on my old Mazda 3) is that they tend to have more bite but, wear out quicker and have more brake dust than OEM. That being said, they were quiet and held up fine until they were fully worn down.
Installed EBC SG two piece racing rotors and EBC RP1 pads on my M2 about three weeks ago. My rotors currently look like this (photos attached) after a recent track day - brakes felt like they were grinding while on track.
Many years ago, I converted my 88 Cabriolet to Corrado G60 front brakes. The pads were junk. They ruined [caused the front rotors to warp] a couple sets of rotors before I pitched the pads.
Write your review
Help others - share your experience with this part.