Right now I use Ferodo DS 3.12 on RE71RS tires. They are pretty high bite and take some getting used to. I might go a rung lower on the friction scale and go with DS 1.11 next time because of that. But the DS 3.12 are unfadeable and very consistent.
Ferodo DS2500 are a great compromise pad. They’re a bit more on the race side of things but I never had issues with them being sketchy. Just get a bit of heat into them early to make sure they’re there.
I always bought BMW genuine brake pads and rotors, and never had an issue. They work great.
I'm going to tell you ferodo DS 1.11. Street driven on them a ton very easy on rotors. Endurance pad, much better than other things I see mentioned a lot like it blows my mind when people think RSL29s are better. I don't have an M3 but I have a 330ci which has the same brakes, and I've had lots of other cars from Corvettes to Mustangs and camaros. Have run that compound a ton.
I think they work just fine. They squealed a bit even after running them in, it stopped however after the first track day where i properly cooked the brakes.
If you want a bit more performance without loosing cold braking, use ferodo ds performance, they're amazing price-quality wise.
I just shopped around for the brake pads for my 2 series, got the front ones done for £150. It was a trusted garage and they inspected the large m sport discs and said there was life for another set of pads on them after this new set. I’m also quite a light braker, so discs and pads tend to last me a long time.
I’m running DS2500 on my GTI and they are just not *quite* robust enough as I have progressed into the more advanced groups.
I switched to the Ferodo DSUno. I am satisfied with its performance, but they seem to struggle because of something. Today, after the track day on Saturday, I checked it and found a crack and a gnawed edge. Also, they have uneven wear, about 0.5-1mm difference. The differences are between the top and bottom parts of the pads, front and back parts and on different sides of the same rotor (inner and outer pads). Uneven wear was with the old pads as well. Recently, I installed brake air ducts, and after going out from the track, the temperature was, in the worst case, 480C degree, which looks fine for these pads. In total, I drove for about 3 hours on tracks, one on a wet track (so no hard braking) and two moderately/hard(8-9/10) braking. The brake rotors are also new, Zimmermann blank, installed with pads. The initial thickness of the pads is 16.4mm (with the plate, the plate is 5.5mm, so the "pure" pad is about 11mm) Currently, I have eaten about 4.5-5mm of the pads in 3 hours of tracking.
My rear pads cracked after 3 months, 4k km of use.
Write your review
Help others - share your experience with this part.
Voted AGAINST engine oil RAVENOL on the rating page
The brake pads NIPPARTS got the first review!
The brake discs Hella got the first review!
The brake discs OEM Suzuki got the first review!
For tires OEM Toyota already 25 reviews.
For tires IRONMAN already 25 reviews.
For starter motor OEM Volkswagen already 25 reviews.
In the rating best ignition coil already 13 brands participate!
In the rating best fuel pump already 5 brands participate!
In the rating best turbocharger already 4 brands participate!
In the auto rating headlights for Volkswagen Golf already 5 brands participate!
In the auto rating brake pads for Mazda 5 already 10 brands participate!
In the auto rating brake pads for BMW M2 already 5 brands participate!
Voted AGAINST engine oil RED LINE on the rating page
Voted AGAINST engine oil PENNZOIL on the rating page
