Brake pads OEM Subaru or Hawk Performance
I autocross a bit and went with Hawk rotors and pads from Tirerack after a bit of mulling it over. Overall fairly happy with them, a little dusty but have NEVER faded while on them hard. Put maybe a hard 5k miles on them so far.
edit- I do have a 1.8 and as mentioned at least once you should consider getting the 1.8's calipers.
I run hawk hps pads on my NA. They've held up to entry level track work and not made much noise on the street. Feel fine when I choose to drive the Miata to work.
Just switched from Stoptech street pads + stoptech drilled and slotted rotors to zimmerman cross drilled rotors with hawk hps5.0 pads. Must say I like my Zimmerman + Hawk setup a lot.
I have been running Hawk HPS 5.0 front and back since my 2019 Stinger GT. Put them on my G70 within the first 500 miles to save the rotors. They do squeak a bit, but they stop without fail and after 35k on my Stinger, never once did I get any vibration on braking.
Hawk hps ceramic pads
+1 on the hawk hp+. Fantastic pad
I run hawk hp+ for street and track use
Hawk LTS improved the pedal in my 460, and unlike power stop, Hawk isn’t the laughing stock of track day communities
I've used hawk hp+ all last year and my first event of this year; they do serve as a pretty good intermediate pad, if I were you I'd go after something similar to it or slightly more track-oriented, but as I understand it the "HPS" pads are not designed for track use, more of just a capable street pad. The HP+ feel great for street driving, but be aware that they do create a fuckton of dust, and oftentimes they squeal like a school bus as you come to a stop. On track, I'd say they do fine for a beginner. I tend to brake on the early side and not as hard as I could, it's an area where I could certainly improve. I have noticed some brake fade at my most recent event, and for that reason I will be installing some G-loc r8's tomorrow, with a backup set of R12's for the front.
My wheel looked the same after an autocross day with my 2017 Mustang GT. I was daily driving these pads a couple years ago, and they nearly destroyed my wheel finish when I left the dust on too long (not to mention how incredibly noisy they were). It took multiple washes with iron remover and the wheels off the car to properly clean it all off.
Write your review
Help others - share your experience with this part.