Brake pads POWER STOP or Ferodo
I installed PowerStop Drilled & Slotted Rotors with PowerStop Pads on my front brake setup. VERY powerful brakes and never had any issues with dust, noise, etc.
I found PowerStop quite good for aftermarket pads. Their Z17 ceramic will be a reasonable OEM-like, low-dust, long-life alternative to your Elantra.
I just bought and installed the power stop z26 street warrior front and rear pads and rotors kit from rock auto for about 460 after taxes and shipping.
Installed smoothly, followed the steps and cleaned the bracket and whatever the rotor mounts to with a wire brush and brake cleaner. Having no issues whatsoever.
Almost 20k miles and still brakes super smooth.
For pads I'm going powerstop z26, good reviews on these and least dusty of the performance ceramic pad options from what people are saying. For rotors I'm going advics high carbon blanks. I've used slotted, drilled/dimples and rotors with both and I've always had cracking or warping issues over time. While they don't look as cool all I care is longevity for a daily driver and I don't planing to track my IS lol.
I have Powerstop pads on my MJ, possibly rotors too, can’t remember for sure though, and they don’t squeak at all. I also run Powerstop pads on my personal truck as well as company trucks and they seem to do very well. Much better than OEM Ram pads, that’s for sure.
Ferodo DS2500 paired with Zimmerman blank rotors and Motul RBF600 is what I use. The tracks I go to are more technical and not fast so it's great for my use case. I imagine if I went to a track where speeds are above 150Km/H and have long, fast corners, I would need better pads. I'm considered intermediate to advanced and last ran a 1:47 at CTMP DDT with worn Vitour Tempesta Enzo tires. I think I can run low 40s this year. I would not track with stock pads. I overheated my pads and brake fade hit hard. The pads melted and I went off the track and almost over the hill at TMP (Cayuga).
Powerstop brakes were good on my 2016 GT, and my Duramax truck. They only lasted 1 year on my Q50. StopTech slotted rotors were a pretty nice upgrade over stock and over the Powerstop brakes. They had zero brake fade and lasted longer than anything else I’ve ever ran.
I switched to the Ferodo DSUno. I am satisfied with its performance, but they seem to struggle because of something. Today, after the track day on Saturday, I checked it and found a crack and a gnawed edge. Also, they have uneven wear, about 0.5-1mm difference. The differences are between the top and bottom parts of the pads, front and back parts and on different sides of the same rotor (inner and outer pads). Uneven wear was with the old pads as well. Recently, I installed brake air ducts, and after going out from the track, the temperature was, in the worst case, 480C degree, which looks fine for these pads. In total, I drove for about 3 hours on tracks, one on a wet track (so no hard braking) and two moderately/hard(8-9/10) braking. The brake rotors are also new, Zimmermann blank, installed with pads. The initial thickness of the pads is 16.4mm (with the plate, the plate is 5.5mm, so the "pure" pad is about 11mm) Currently, I have eaten about 4.5-5mm of the pads in 3 hours of tracking.
My rear pads cracked after 3 months, 4k km of use.
Write your review
Help others - share your experience with this part.