Brake pads Carbotech or OEM Honda
I’m running Carbotech XP10 in my AP’s and the cold squeal is obnoxious. Once they’re really good and hot it goes away but it’s definitely just a trade off of good pads. Mine drag every so slightly when turning the wheel by hand but never enough I’ve been concerned about it. They still work very, very well.
I had aftermarket front brakes installed by a local mechanic for around $300. They ended up squeaking constantly and just didn’t feel right. I eventually had them redone with genuine Honda brakes at the dealership — it cost me $575, but the difference was night and day. No noise, smooth feel, and it came with a 12-month warranty.
I use carbotech xp10/8. I don't bother to switch. it makes a bit of noise if I street drive it too much but nothing really bad. it beds back in just fine after one or two warm up laps
XP for track use and 1521 for street. No need to rebed pads. Just swap and go. Carbotech says this and I’ve head zero issue myself doing this
I just switch between track and OEM pads. I can usually get 4 to 5 tracks days out of the Carbotechs that I run. I drive my car to the track, so by the time I get there the track pads have had plenty of time to make friends with the rotors. Same thing with the OEM pads. It just take a little bit of driving for them to settle in.
carbotech xp10/xp8(f/r), not a daily but the car sees plenty of street miles. they are noisy and dusty but this setup has been perfectly fine for me.
2019 Honda Civic LX 2.0 bought brand new and has 107,000 miles on it with original brakes. Rotors and pads. Not squeaking yet. Excellent!
I’ve used carbotech XP10 for years because it’s the only pad that has never had any of these kinds of problems. Also also swapped between 1521 and XP10 seamlessly. The only time I had a problem like this was when I used some very cheap rotors that couldn’t handle the track abuse, you could actually see the rotor surface getting pitted. Yours look fine by comparison.
2019 civic. Replaced front pads and rotors at 90k miles but only because road salt fucked up rotors which caused the pads to wear unevenly.
I tried the carbotech 1521 to try to get silent street pads with better bite but no dice, it’s the same as the OEM akebonos
Write your review
Help others - share your experience with this part.